I received these Holybro Tekko32 35A ESC a few months back but I haven’t had time to test them yet on a mini quad. Anyway I want to get it out of the way so here is an overview of these ESC’s. We will take a look at the features and build quality, and I will update this post once I have tested them.
The Tekko32 ESC runs BLHeli_32 firmware. Here are the spec:
- 2S – 6S
- 35A Con., 50A burst
- Weight: 5.2g
- Dimension: 15x30mm
- Supports DShot1200 Protocol
It has on-board current sensor, and there are two LED’s on both sides of the ESC. So it doesn’t matter which side you mount your ESC on the quad the light will always be visible.
The Tekko32 seems to have the exact same spec and design as the Airbot Wraith32 V2 ESC’s, maybe it’s just a rebranded product but I am not entirely sure.
It has two huge arrays of capacitors on sides for noise filtering which is good to see :)
The solder pads for ESC signal, signal ground and ESC telemetry are conveniently located at the top edge of the ESC. The pads for power and motor are well sized, and available on both sides which makes working with these ESC’s really easy.
I have to say, the build quality of the Tekko32 ESC is top notch, probably one of the best I’ve seen, and so far I really like the layout.
- Kakute F4 AIO V2 + 4x Tekko32 35A BLHeli_32 ESC’s
- Kakute F4 AIO V2 + 4x Tekko32 35A BLHeli_32 ESC’s + Atlatl HV VTX
I am testing these ESC’s on my Flipmode quad, check out the build log to find out any updates and videos regarding them.