Replace Lens Module – Runcam HD Camera

So I did my first review of the Runcam HD Camera, but they told me the lens I had was probably faulty so they sent me a lens module replacement. Here is how I swapped out the lens module on the camera.

1. open the housing first, there are 3 parts inside: the battery, the PCB board and the lens module.

open-runcam-hd-circuit-inside

3. The lens module is connected with PCB board via a flat cable. There is a DIP switch on the cable connector, you switch it up, to take off the lens module.

runcam-hd-circuit-boad runcam-hd-circuit-boad

4. Replace the module, and press the DIP switch, and reinstall the battery and PCB board back to the housing.

runcam-hd-camera-remove-lens-module

Leave a Reply

Your email address will not be published. Required fields are marked *

Are you Robot? *

I am moving all supports to this forum IntoFPV.com (at least for now)... So if you are looking for help, or want to help people, I strongly recommend joining this community. Feel free to share your projects, builds and knowledge too!