Electronics

Mischa showed us how he upgraded his Attitude V2 Goggles with a Diversity video receiver module, that is designed for the Fatshark Dominator V2/V3/HD. He also added a faceplate on this pair of goggles.

The fact that VTX nowadays are getting smaller, it means there is less surface area to let the heat go and often cause overheat issues. This is especially the case with high power units like the TS5828 600mW. …

Building a DIY CNC machine might be easier that you thought. Especially so if you are capable of building a quadcopter from scratch, it’s should be straight forward enough. Jocelyn Da Prato shares with us how he built his CNC machine …

Here is a review of the Runcam Swift – a small form factor FPV camera. It is tiny but Runcam assured us that it has the same high performance as the PZ0420M, and its flexible mounting …

The Skyline32+OSD is a flight controller with integrated minimOSD, it makes OSD setup and wiring much easier. In this post we will take a look at the features and pinouts of this FC board.

Flyduino kindly sent us a set of the new KISS 24A ESC Race Edition (RE) to try out. In this post we will go through the key features, performance testing, and finally some guides on …

Runcam sent me their OWL Starlight Camera for review, which is designed for night FPV flying.

X-Racer F303 Flight controller is built with the next generation F3 processor, which allows more configuration options and great for multirotors FPV racing. More importantly, it doesn’t cost an arm and a leg!

Mischa, a group member of MI (multicopter international) kindly shared with us how he soldered a memory chip on a Naze32 Acro board.

When choosing motors and propellers for mini quad, we often just listen to rumours, or what’s suggested by the manufactures. To determine the optimal motor and propellers combination for your quadcopter and multirotors, the most …

In this tutorial we will have a overview on both normal size and Micro MinimOSD, how to configure and use MW-OSD firmware, connect it to Naze32 and RX, and firmware flash.

So I did my first review of the Runcam HD Camera, but they told me the lens I had was probably faulty so they sent me a lens module replacement. Here is how I swapped …